MRL traction lift with machinery contained
in a cabinet at the side of the shaft

Key features
Lifts designed in compliance with CABIFIT model are characterized by the machinery (gearbox, control panel, panel with main and lighting switches) contained in a cabinet. They offer a very wide range of solutions, with various loads, dimensions, and car finishes, landing and car door type and dimensions.

Benefits
The machinery occupies an area of less than 0.4 m2, instead of about 4 m2 for the traditional machine room.
The cabinet height is 2 metres, which is the minimum height for the area where maintenance operations are carried out.
It can be located at any landing.
The cabinet dimensions are always the same, regardless of the installation features (load, speed and number of stops).
Gearbox and control panel components are very close together.
This makes easier assembling, maintenance and rescue procedures.
Most of the lift load rests on the car and counterweight guides.
Load bearing beams to fix onto the shaft walls are not required.
The frequency control system, provided by a high quality inverter, guarantees a high standard of ride comfort, reduced current consumption peaks and energy and money saving, as well as reduced mechanical stresses and temperature of the gear motor.

Safety
The cabinet can be opened only by a specific key. When it is open, it clearly indicates the area necessary for maintenance and rescue operations.
Compared to models with the machine in the upper part of the shaft, assembling and machine maintenance operations do not require access to the inside of the shaft and can be accomplished in a standing position (the gearbox is fixed to the floor and rests on a special frame, therefore its position is extremely stable).
Stopping devices for the car are not required during gearbox maintenance and it is not necessary to control the machine from the outside.
Comparing this model to those with the machine in the shaft headroom, maintenance operations can be carried out from the floor.
The rescue operations can be carried out by any trained person and these are always possible in any fault situation.